Efficient Networks SpeedStream 4000 Spécifications télécharger pdf (Page 268)

100

101

Chapter 7: WAN Interface Commands Efficient Networks

Router family

Command Line Interface Guide

Page 7-8 Efficient Networks

Parameters

Example

The following command example requests a speed of 512 kilobits/second. However,

512 is not one of the discrete speed values allowed, so the next lower value, 500

kilobits/second, is set, as indicated by the message.

Response

The following is a typical response from a request for the current speed.

remote setatmtraffic

Sets ATM traffic-shaping on a remote router. ATM traffic-shaping allows the user to

set the average rate at which cells are sent, that is, the Sustained Cell Rate (SCR), to

a value lower than the ATM link speed, the Peak Cell Rate (PCR).

ATM traffic-shaping should be used to allocate bandwidth whenever more than one

remote router is defined. Enter a remote setATMTraffic command for each remote.

For example, if you have five remotes, enter five commands to allocate the

bandwidth.

If no ATM traffic values are set, ATM traffic for the remote is shaped using UBR

(unspecified bit rate).

If a CBR (constant bit rate) is required, then specify 1 as the Maximum Burst Size

(MBS). If a VBR (Variable Bit Rate) is required, specify a value greater than 1 as the

Maximum Burst Size (MBS).

Mgmt Class

Network (R/W)

Input Format

remote setATMTraffic <scr> <mbs> <remoteName>

***

When entered with no parameters, the current upstream speed is

displayed.

<kb/s>

Integer, 125-8000

Upstream speed requested in kilobits/second.

-> atm speed 512

ATM Upstream Rate: 500 Kb/sec or 1179 cells/sec

-> atm speed

ATM Upstream Rate: 326 Kb/sec or 768 cells/sec

1 2 ... 263 264 265 266 267 268 269 270 271 272 273 ... 515 516

Commentaires sur ces manuels

Pas de commentaire

Efficient Networks SpeedStream 4000 Spécifications Page 268

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Efficient Networks SpeedStream 4000