Efficient Networks Router family Command line interface Guide de l'utilisateur télécharger pdf (Page 30)

30 Chapter 2. Planning for Router Configuration

Essential ConÞguration Information

This section describes the configuration information associated with each Link Protocol/Network Protocol

combination and also provides configuration information for the Dual-Ethernet router.

If you are using Link and Network Protocols:

1. Determine which Link Protocol/Network Protocol association you are using from your Network Service

Provider (NSP).

2. Select (click) one of the following Link/Network information that applies to your situation:

PPP Link Protocol with:

¥ IP Routing Network Protocol, on page 31

¥ IPX Routing Network Protocol, on page 33

¥ Bridging Network Protocol, on page 35

RFC 1483 or RFC 1490 Link Protocol with:

¥ IP Routing Network Protocol, on page 36

¥ IPX Routing Network Protocol, on page 37

¥ Bridging Network Protocol, on page 38

MAC Encapsulated Routing: RFC 1483MER or RFC 1490MER Link Protocol with:

¥ IP Routing Network Protocol, on page 39

FRF8 Link Protocol with:

¥ IP Routing Network Protocol, on page 41

3. Collect the information applicable to your Link/Network Protocol association. This information will be used

later in conjunction with the Configuration Tables for easy configuration of your router based on your Link/

Network protocol. These configuration tables provide step-by-step instructions for a basic configuration for

each Link/Network protocol.

Note: Use the blank Network Information Worksheets in Appendix A to collect your network information.

If you are using a Dual-Ethernet Router:

Select (click) one of the two following configurations that applies to your situation:

Configuring the Dual-Ethernet Router as a Bridge, on page 42

Configuring the Dual-Ethernet Router for IP Routing, on page 43

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 322 323

Pas de commentaire

Efficient Networks Router family Command line interface Guide de l'utilisateur Page 30